• Model NO.：DTQX-1
• Material：Galvanizing
• Ambient Temperature：-10ºC~+40ºC
• Relative Humidity：No More Than 80% (Below 20 ºC)
• Transport Package：Other
• Specification：1684× 1562× 4290mm
• Trademark：Jianhua
• Origin：Shandong
• HS Code：8438500000
• Production Capacity：300 Head,Shift Output

Basic Info.

Model NO. DTQX-1 Material Galvanizing Ambient Temperature -10ºC~+40ºC Relative Humidity No More Than 80% (Below 20 ºC) Transport Package Other Specification 1684× 1562× 4290mm Trademark Jianhua Origin Shandong HS Code 8438500000 Production Capacity 300 Head/Shift Output

Product Description

Agricultural machinery cattle carcass cleaning machine meat process machine
The machine is a special equipment developed by our company for the cleaning of bovine dichoid. Equipment is not embroidered steel production, high-pressure spray cleaning, high degree of automation.  

                


 the point of operation safety
1) It is strictly forbidden to extend other things such as hands into the machine when the machine is in operation, so as to prevent injury to the person or damage the machine;
2) If the machine has abnormal working sound, stop the machine immediately to prevent the machine from being damaged, and the personnel are injured;
3) the machine must be cleaned and maintained at the time of stopping, and make sure that the power supply has been cut off and the signboard is hung;
4) when the work is finished, turn off the power supply;
5) the operator shall have knowledge of the operation of machinery and electrical appliances and be in good health; 
6) The operator shall be familiar with the structure, service performance, safety procedures and the instructions of the machine;
7) The operators shall be subject to post training and work with certificates;
8) daily inspection before each shift operation;
9) The user must establish the necessary rules and regulations and safety operation procedures. 




repair
Repair, adjust or replace parts immediately if they do not meet the requirements. The following requirements should be achieved in maintenance:
1) the replacement should be the same as the raw material performance during maintenance;
2) maintenance and repair shall not be allowed when the machine is in working condition. 



Inspection, maintenance, maintenance and troubleshooting methods:
1) Lubricating the rotating part frequently;
2) cleaning the equipment after each work to keep the body clean inside and outside;
3) because the machine is working in vibration state, the connecting bolt should be checked for looseness in the process of use.